DIY Horizontal Warping Mill

I WILL HAVE LIMITED INTERNET ACCESS UNTIL JANUARY 31ST. IF YOU PURCHASE PLANS, I WILL BE ABLE TO EMAIL THEM TO YOU WHEN I AM BACK ON LINE.

The plans are sent to the email address included with the PayPal payment. If you have not whitelisted joyofweaving.com in your email filters, it will end up in your JUNK/SPAM folder. Check the JUNK/SPAM folder of the email address used to make your payment. Check your PayPal account to ensure the email address on file is current.

diy horizontal warping mill that folds flat for storage plans

You don't need a PayPal account to use this button

Thank you ever so much. Your purchase means a lot to me (more than you'll ever know).

Only $5.98 USD

The plans are sent to the email address included with the PayPal payment. If you have not whitelisted joyofweaving.com in your email filters, it will end up in your JUNK/SPAM folder. Check the JUNK/SPAM folder of the email address used to make your payment. Check your PayPal account to ensure the email address on file is current.

If it says alice_aod, it went to the right place. No worries!

diy horizontal warping mill that folds flat for storage

The plans are sent to the email address included with the PayPal payment. If you have not whitelisted joyofweaving.com in your email filters, it will end up in your JUNK/SPAM folder. Check the JUNK/SPAM folder of the email address used to make your payment. Check your PayPal account to ensure the email address on file is current.

diy  horizontal warping mill folds flat for storage

My friend Linda posted a video on how to use a horizontal warping mill with multi-threads using a paddle for super fast warping!


Comments.
Pages:
123
Judy Fearn
0

I bought the plans for the horizontal warping mill not long ago. Today, hubby and I went to the lumber store and got the materials. We went out to "The Man Garage" and started cutting and had it assembled in in under 2 hours. It's awesome! Thanks

Published on August 06th, 2017 - 15:43 PM, from Rochester, MN
Joyce
0

So glad you're enjoying it! Thank you for your support!

Published on August 11th, 2017 - 13:12 PM, from Planet Earth
Gaylynn
0

I have a question. I built my mill today but it squeaks really bad. My question is should the middle dowel turn with the mill or should the warp part turn on the axle( middle dowel) ?

Published on August 03th, 2017 - 18:45 PM, from Washington state
Joyce
+1

The only thing that turns is the frames. You might have to make the center holes in the frames a little bigger or put some soap in the holes to stop the squeaking. If it's very humid in your area, that will effect things so keep that in mind too.

Published on August 11th, 2017 - 13:14 PM, from Planet Earth
Write a New Comment
Maximum number of characters for comment: 250
 If you cann't see Verification Code clearly.
Write Verification Code(Required field)